Logo  




Pirate-4x4.Ru - BF Goodrich Krawler
In-Cab Winch Control from www.RoadlessGear.com
By Mustard Dog

 

Mustard Dog, with assistance from Pedro Zuk, installs an In-Cab Winch Control from www.RoadlessGear.com

I was cruising thru the PBB vendor forum and came across an item that caught my attention. An in cab winch control kit. I know many of you are saying "So what!, I can make one of those myself" But... can you buy the switches & wires and fab a nice little backing plate for the low price of $29.95 that Roadless Gear sells this complete kit for? Me neither! So I went to their website and ordered one up.

RLpic1.JPG A couple of days later the unit showed up. Very nice setup! It came pre-wired with a set of easy to understand instructions with pictures. My only gripe was that it only came with 6 feet of wire, however they will supply as much as you need, within reason.
RLpic2.JPG I simply bought a three wire 18 gauge extension cord for three bucks and used that.

RLpic5.JPG

RLpic6.JPG

The first step was to figure out a place to put the controller. My dash was a little full, so we decided to mount the control unit to the front of my Tuffy console.

RLpic3.JPG

 

My winch is a Warn X8000i that's about 5 years old, so it is a three prong unit that is very basic.
RLpic4.JPG After removing the top cover of the winch, you can see the solenoids that we will be working with.

RLpic7.JPG

RLpic8.JPG

We started at the winch by drilling a hole in the side of the case, adding a grommet, pushing the cord thru and stripping it. We then routed the wire back to the center console.
RLpic9.JPG Next we connected the white wire from our extension cord to the "out" at the switch and to the correct solenoid on the winch. For my winch it was the first solenoid (A) in. Then we did the same with the black wire to the "in" switch and the second solenoid (B). As upi can see in the pic, the white wire went to the green at the winch and the black went to the black.

All that was left was adding power and ground to the switch, which we wired to only get power if the key was in the "on" position.

All in all, this kit is a great product. It is awesome not having to fumble with digging for the remote in the toolbox, having to get out and plug it in, making sure you don't run over the cable, etc. Now I simply flip a switch and start winching!

Contact Info
www.RoadlessGear.com

(208) 660-6905
sales@roadlessgear.com

CLICK HERE TO GO TO PREVIOUS PRODUCT REVIEWS!